Waspmote Technical Guide
Development website
  • Initial page
  • Introduction
  • Waspmote kit
  • Waspmote Plug & Sense! - Encapsulated line
  • Hardware
  • Architecture and system
  • Interruptions
  • Energy system
  • Sensors
  • 802.15.4/ZigBee/RF modules
  • LoRaWAN modules
  • LoRa module
  • Sigfox modules
  • WiFi PRO module
  • WiFi PRO V3 module
  • Bluetooth Pro module
  • Bluetooth Low Energy module
  • 4G module
  • NB-IoT / Cat-M module
  • RFID/NFC module
  • Industrial Protocols
  • Expansion Radio Board
  • Over the Air Programming (OTA)
  • Encryption libraries
  • GPS
  • SD memory card
  • Energy Consumption
  • Power supplies
  • Working environment
  • Interacting with Waspmote
  • Meshlium - The IoT Gateway
  • Certifications
  • Maintenance
  • Disposal and recycling
  • Documentation changelog
Powered by GitBook
On this page

Was this helpful?

Maintenance

  • In this section, the term "Waspmote" encompasses both the Waspmote device itself as well as its modules and sensor boards.

  • Take care when handling Waspmote, do not let it fall, knock it or move it roughly.

  • Avoid having the devices in high temperature areas as it could damage the electronic components.

  • Avoid aggressive environments (corrosive gases, animals, excessive/condensing humidity or atmospheres with salt suspended in the air).

  • The antennas should be connected carefully. Do not force them when fitting them as the connectors could be damaged.

  • Do not use any type of paint on the device, it could harm the operation of the connectors or buttons.

PreviousCertificationsNextDisposal and recycling

Last updated 3 years ago

Was this helpful?