Waspmote Technical Guide
Development website
  • Initial page
  • Introduction
  • Waspmote kit
  • Waspmote Plug & Sense! - Encapsulated line
  • Hardware
  • Architecture and system
  • Interruptions
  • Energy system
  • Sensors
  • 802.15.4/ZigBee/RF modules
  • LoRaWAN modules
  • LoRa module
  • Sigfox modules
  • WiFi PRO module
  • WiFi PRO V3 module
  • Bluetooth Pro module
  • Bluetooth Low Energy module
  • 4G module
  • NB-IoT / Cat-M module
  • RFID/NFC module
  • Industrial Protocols
  • Expansion Radio Board
  • Over the Air Programming (OTA)
  • Encryption libraries
  • GPS
  • SD memory card
  • Energy Consumption
  • Power supplies
  • Working environment
  • Interacting with Waspmote
  • Meshlium - The IoT Gateway
  • Certifications
  • Maintenance
  • Disposal and recycling
  • Documentation changelog
Powered by GitBook
On this page

Was this helpful?

Working environment

PreviousPower suppliesNextInteracting with Waspmote

Last updated 4 years ago

Was this helpful?

The Integrated Development Environment (IDE) is used for writing the code and uploading it to Waspmote and Plug & Sense!. It is also used to monitor serial output and for debugging. This IDE contains the Waspmote API (the API is the set of all libraries Waspmote needs for compiling programs). New API versions are released instantly by Libelium whenever improvements are made or bugs fixed.

All information about the IDE installation and operation can be found in the .

All the documentation is located in the in the Libelium website.

IDE User Guide
Development section
Figure: Waspmote IDE