Plug & Sense! Technical Guide
Development website
  • Initial page
  • General and safety information
  • Important: read before use
  • Introduction
  • Waspmote vs Waspmote Plug & Sense
  • General view
  • Sensor probes
  • Internal sensors
  • Radio modules
  • Industrial Protocols
  • GPS module
  • Internal storage
  • On/off button
  • Resetting Waspmote Plug & Sense! with an external magnet
  • USB port
  • External solar panel
  • External Battery Module
  • Vent plug / pressure compensator
  • Antenna
  • Sensor protection
  • Battery
  • Models
  • Programming
  • Programming Cloud Service
  • Uploading code
  • Over the air programming -- OTA
  • Encryption libraries
  • Installation
  • Energy consumption
    • Energy system
  • Recommendations
  • Documentation changelog
  • Certifications
  • Maintenance
  • Disposal and recycling
Powered by GitBook
On this page

Was this helpful?

Internal sensors

PreviousSensor probesNextRadio modules

Last updated 4 years ago

Was this helpful?

Accelerometer

Waspmote has a built-in acceleration sensor which informs the mote of acceleration variations experienced on each one of the 3 axes (X, Y, Z). The integration of this sensor allows the measurement of acceleration on the 3 axes (X, Y, Z), establishing 2 kinds of events: Free Fall and Direction Detection Change.

Complete information can be found in the

https://development.libelium.com/accelerometer-programming-guide/
Figure: Axis direction in Waspmote Plug & Sense!