BaseN
Last updated
Last updated
Follow this short instruction to get Meshlium synchronized to BaseN Platform running. This guide assumes that you are already a customer of BaseN and have access to your BaseN admin wiki.
In your chosen wiki page, configure the following minimum setup for synchronizing with the BaseN Platform.
Id: Unique ID of this Microagent receiver.
Path: Measurement data path for data storage.
Username: Username for authentication of Microagent receiver.
Password: Password for authentication of Microagent receiver.
Use the same Microagent receiver parameters in the Meshlium BaseN Cloud Connector plugin.
BaseN plugin is located in:
Manager System -> Cloud Connector -> Basic Cloud Partner -> BaseN
BASEN_URL: Usually http://customername.basen.com/_ua/customername/.
BASEN_ID: Unique ID of this Microagent receiver.
BASEN_USER: Username to authenticate the Microagent receiver.
BASEN_PASSWORD: Password to authenticate the Microagent receiver.
After setting the parameters, save the configuration clicking on the "Save" icon.
Click on "Start" for Cloud Synchronization. A green icon should start rolling to indicate synchronization is running.
Go to the BaseN Platform wiki where the Microagent Receiver and MicroAgentConfig were configured, and check under "Debug Information for <id>" and "Stats" that the Observer Request Counts does show requests arriving.
