Sparkster

The Sparkster cloud platform simplifies setup, just login and set rules for what data should be sent to the cloud.

Figure : Sparkster login panel

Register Meshlium

Login to the Sparkster and name your Meshlium, then click the "Register" button.

Figure : Meshlium name

Name your sensors

Name your sensors and specify the location of sensors, then click on the "Update" button to save.

Figure : Sensor names

Create/update rules

Determine how frequently you would like your data to be updated to the cloud, click the "Update" button to save. The lower the frequency, the lower the bandwidth consumed.

Create the rules of what data needs to be sent from the device to the cloud and click on the "Update" button to create/update rules. Examples of these rules include the maximum temperature detected within the update period or notifying the cloud if the battery level is less than 50%. In addition to the value, you may also send a message to the cloud.

Figure : Sparkster rules

Controlling synchronization

Once you have created all your rules, click the "Start" button to begin the transmission to the cloud. Click the "Stop" button to stop the data transmission.

Figure : Connection status

Controlling the application

Click on the "Stop App" button to stop the Sparkster application on your Meshlium.

Note: Clicking on the “Stop App” button will log you out and stop any data transmission to the cloud. This will also terminate the Sparkster Application.

Click on "Logout" button to logout from the application.

Note: Clicking on the “Logout” button will log you out and stop data transmission to the cloud.

Figure : Stop or log out